AUTOOL M518 No Gas MIG Welder, Gasless IGBT Inverter Automatic Feed Flux Core Wire Welding Machine 110V Autool
AUTOOL M518 No Gas MIG Welder, Gasless IGBT Inverter Automatic Feed Flux Core Wire Welding Machine 110V Autool
AUTOOL M518 No Gas MIG Welder, Gasless IGBT Inverter Automatic Feed Flux Core Wire Welding Machine 110V Autool
AUTOOL M518 No Gas MIG Welder, Gasless IGBT Inverter Automatic Feed Flux Core Wire Welding Machine 110V Autool
AUTOOL M518 No Gas MIG Welder, Gasless IGBT Inverter Automatic Feed Flux Core Wire Welding Machine 110V Autool
AUTOOL M518 No Gas MIG Welder, Gasless IGBT Inverter Automatic Feed Flux Core Wire Welding Machine 110V Autool

AUTOOL M518 No Gas MIG Welder, Gasless IGBT Inverter Automatic Feed Flux Core Wire Welding Machine 110V

$264.00
$264.00
Sold Out

AUTOOL M518 No Gas MIG Welder, Gasless IGBT Inverter Automatic Feed Flux Core Wire Welding Machine 110V

Product Introduction：

The AUTOOL M518 welding machine applies the most advanced inversion technology.
The principle of inversion is to transform the power frequency of 50Hz/ 60Hz into direct current and invert it into high frequency through high-power device IGBT, then perform voltage-drop and
commutation with the output high-power D.C power supply via Pulse Width Modulation (PWM).
Since the switch power inversion technology is adopted, the weight and volume decrease greatly while the conversion efficiency increase of more than 30%.
The machine is self-shielded flux cored welding machine, which is equipped with unique electronic reactor circuit, which can precisely control the short-circuiting transfer and mixed transfer resulted in better performance than other machines. Compared with silicon controlled welding machine and tapped welding, our products have the following advantages: stable wire feed rate, portable, energy-saving, electromagnetic noise free.

DAILY MAINTENANCE OF AUTOOL M518 IGBT INVERTER GAS SHIELDED WELDING MACHINE

  1. Regularly use dry compressed air to remove dust. If the welding machine is used in an environment with heavy smoke and air pollution, it needs to be dusted at least once a month.
  2. Check the electrical connectors of the welding machine to ensure perfect contact (especially the plug and socket). Fix loose joints, and when oxidation occurs, use sandpaper to remove the oxide film, and then reconnect.
  3. Prevent water from entering the equipment. If it accidentally enters the water, dry it immediately. Use a tramegger to measure the insulating material to ensure that it is qualified for use.
  4. Every 300 hours of operation of the wire feeder,the motor carbon shall be polished, 
    the armature commutator and the reducer shall be cleaned, and the turbine, scroll rod and bearing shall be coated with 2 # molybdenum disulfide lubricating grease.
  5. If the welding machine will not be used for a long time, it should use the original packaging and store it in a dry environment.